Tile provides an attractive bathroom or kitchen wall covering because it’s both waterproof and durable, but locating the studs can prove difficult. If you need to install something intended to hold a lot of weight, like a safety bar stud place is an issue. The conventional method of place won’t operate on a wall confronted with tile that is thick. Employing the measurements in standard construction paired with an electronic stud finder can reveal the areas of the studs.
Measure throughout the wall, starting at a corner. Mark the tile with a piece of tape 16 inches from the corner. Studs are spaced so this is the place of a stud.
Pass the detector of a digital stud finder over the wall round the tape mark to verify the location of the stud. The stud beeps finder up lights or does a combination of both, depending upon the design.
Move the tape to mark the actual location of the stud if your first measurement was off.
Should you need to find over 1 stud on the 24, Quantify 16 inches from the confirmed stud position into another stud. Confirm the place with the finder. Repeat until you locate of the studs.