Replacing an older toilet is an efficient method to update your bathroom while saving money in your water bill to you. Conservation actions including the California Green Building Standards Code need that new bathrooms satisfy the Environmental Protection Agency WaterSense system requirements, which currently require a a maximum of 1.28 gallons per flush (GPF). Many suppliers provide partly assembled bathroom-in-a box deals that contain nearly every thing need to install a water-conserving bathroom.
Unpack the bathroom cautiously and examine the tank, bowl and tank lid for injury. Make sure together with the bathroom are current as well as in excellent situation, that all of the gaskets, seals and fasteners integrated. Before the installation is complete, put the tank lid apart in a secure location.
Clean particles or any wax from ground, the toilet flange and drain opening. Remove the outdated T bolts in the flange and discard them. Examine the bathroom flange for indications of injury and make sure it is securely connected to the ground. Install 5/16- by slipping them in the slots of the toilet flange inch-diameter T bolts. The slim plastic washers integrated using the bolts from the flange. This helps to support the the bolts upright and in in place to the bathroom foundation holes for simple insertion.
Turn the toilet-bowl upside-down on an area that is soft. Peel the protective cover from a wax ring that is strengthened. Press the ring into place across the toilet-bowl outlet horn with all the flange. Lift the bowl and flip it right-side-up while continuing to to carry it off the ground. Do not crush or dislodge the wax ring.
Lower the toilet-bowl onto the while guiding the holes into placement on the T bolts in the bottom. Press down on the bathroom bowl to seat the wax ring, then take a seat on on the bowl to ensure the toilet is in spot. Place alevel . Adjust the bowl if required to le Vel by inserting shims underneath the fringe of of the base. Install a bolt cap spacer onto all of the T bolts, followed closely by with a steel washer. Thread on the nuts and tighten them securely using an adjustable wrench. Do not over-tighten the nuts or the bowl can be cracked by you. Trim any excessive shim materials having a utility knife a way. Cover the very top of the T bolts using the bolt caps that are ornamental. Cut the bolts over the nuts using a hack-saw if required to to add the caps.
Slip a rubber gasket in the base of the tank and insert them although the holes onto all the tank-to-bowl bolts. Place a steel washer and nut on every bolt from beneath the the tank and tighten. Do not over-tighten the nuts or the tank can be cracked by you. Press the rubber tank that is soft -to-bowl seal throughout the tank flush valve outlet on the base of the tank. Turn over the tank and place it guiding the bolts watchfully. A rubber washer onto all the bolts from beneath the the bowl, accompanied by with a steel washer. Thread on the nuts before the tank is le Vel and securely in spot and tighten. Do not over-tighten the nuts or the tank can be cracked by you.
Examine the the inner of the tank to ensure chain and the lever are related precisely and that all factory- elements are in location. Attach the water-supply line to the part of the fill-valve protruding through the underside of the tank. Tighten byhand, or as instructed by the maker for the supply-line link kind.
Turn on the water-supply and look for for leaks. Allow the tank to fill and after that flush the bathroom to test for appropriate procedure. Wipe up any water or particles from your floor round the bathroom foundation. Apply a bead of caulk throughout the bottom to seal it to the flooring.
Install a bathroom seat in line with the instructions included together with the seat. Consult the directions of the bathroom manufacturer’s preceding to utilizing the bathroom for just about any special procedures that have to be followed.